Ricoh Pro C7200S Troubleshooting Manual page 465

This is likely to occur if:

Using thin paper

Using coated paper

A lot of toner adheres to the paper leading edge due to a solid image

Printing with a narrow margin on the leading edge

A lot of toner adheres to the paper trailing edge due to a solid image

Printing with a narrow margin on the trailing edge having a high magnification rate)
Solution
If the mask width of paper leading edge can be widened, or the erase margin of trailing edge
can be widened;
1.
Register the target paper brand to "Custom Paper Settings" if it is not registered.
2.
In "Custom Paper Settings", set the items below to +0.5 mm against the current value.

No.1239-01 "Margin:BW/FC/S: Leading Edge"

No.1239-02 "Margin:BW/FC/S: Trailing Edge"

No.1239-03, -05, -06 "Margin: FCS:Leading Edge"

No.1239-04, -07 to -10 "Margin: FCS:Trailing Edge"
3.
Print the target image.
4.
Is the problem solved?
YES: Finished.
NO: Repeat the steps 1 through 2. If the problem is not solved by the maximum value, no further
improvement can be expected in the field. Ask customer for using other paper.
If the mask width of paper leading edge cannot be widened, or the erase margin of trailing
edge cannot be widened;
1.
Is it possible to change the image position?
YES: Go to step 2
NO: No further improvement can be expected. Ask customer for using other paper.
2.
Set No. 0103 "Image Position: With Feed: Side 1" in "Adjustment Settings for Operators" to +0.5
mm against the current value.
In "Custom Paper Settings", set No. 1101-02 "Image Position: Side 1: With Feed" to +0.5 mm
against the current value.
3.
Adjust the image position of Side 2 along with Side 1.

Set No. 0104 "Image Position: With Feed: Side 2" in "Adjustment Settings for Operators" to
+0.5 mm against the current value.

In "Custom Paper Settings", adjust it with No. 1101-04 "Image Position: Side 2: With Feed".
4.
Print the target image.
5.
Is the problem solved?
YES: Finished.
3.Troubleshooting: Paper Delivery Problems
461