Ricoh Pro C7200S Troubleshooting Manual page 265

SC No. Level








SC No. Level
SC752- D Perfect Binder: Sub grip HP position lag error
36
While passing the signature, the sub grip HP sensor did not go OFF, even though
the sub grip motor had operated for 500 ms.









SC No. Level
SC752- D Perfect Binder: Signature move main grip position late error
37
While sub grip was passing the signature, the signature move MG position sensor
did not go ON, even though the signature move motor had operated for 3000 ms.
At the timing of the movement of the signature from sub grip to main grip, the
signature was still gripped by the main grip at the rotation HP sensor.








Error Name/Error Condition/Major Cause/Solution
Sub grip motor defective
Sub grip HP sensor defective
Reconnect the connector.
Replace the signature movement motor.
Replace the signature movement HP sensor.
Replace the slave control board.
Replace the motor harness.
Replace the sensor harness.
Error Name/Error Condition/Major Cause/Solution
Sub grip motor defective
Sub grip HP sensor defective
Connector harness loose, broken, defective
Reconnect the connector.
Replace the signature movement motor.
Replace the signature movement HP sensor.
Replace the slave control board.
Replace the motor harness.
Replace the sensor harness.
Error Name/Error Condition/Major Cause/Solution
Signature movement motor defective
Signature MG position sensor defective
Reconnect the connector.
Replace the signature movement motor.
Replace the signature MG position sensor.
Replace the slave control board.
Replace the motor harness.
Replace the sensor harness.
1.SC Codes
261