Ricoh Pro C7200S Troubleshooting Manual page 650

11.Image Quality Problem: Full Page
1.
Check the required refresh amount in SP3-820-011 to 015 (Tnr Refresh Mode).
2.
Is there any color that exceeds 10,000 mm?
YES: Go to next step.
NO: Go to step 4.
3. Select "26: Full Dot Pattern" in SP2-109-003 (Test Pattern :Pattern Selection) to print a solid image.
4.
In the "Adjustment Settings for Operators" menu, execute No. 0501 "Execute Process Initial
Setting" (SP3-020-001).
5.
Print the image. Is the printed image acceptable?
YES: Finish
NO: Go to next step.
6.
Check the value of developer in SP3-930-051 to 055(Life Prediction: Dis.).
7. Is "1" displayed for any colors?
YES: Replace the developer for the applicable color and then print the image and check quality.
NO: No further improvement can be expected in the field.

If the problem is not solved by "Solution 2," check the required data (SMC data, paper brand,
etc.) and contact your supervisor.

After taking the above measures, do the color calibration adjustment of the DFE.
Toner Scattering: Lines
Toner scattering occurs for a portion of lines.
This may occur in a line that is 5 mm or less from the leading edge, or in a line that is 1.5 to 5 mm from
the trailing edge of an image.
[A]: Toner Scattering
This is likely to occur if:
Printing lines on coated or smoothness paper
646