Ricoh Pro C7200S Troubleshooting Manual page 302

1.SC Codes
SC No. Level
SC No. Level
SC753- B Perfect Binder: Glue level thermistor error 1
45
After glue warm-up completed, the glue level thermistor detected a temperature of
over 170 degrees for more than10 sec.






After the repairs, cancel the low performance mode, and then turn the power
off/on.
SC No. Level
SC753- B Perfect Binder: Glue level thermistor error 2
46 After glue warm-up completed, the glue level thermistor detected a temperature
less than 100 degrees for more than10 sec.






After the repairs, cancel the low performance mode, and then turn the power
off/on.
SC No. Level
SC753- B Perfect Binder: Thermistor disconnect error
47
The glue abnormal temperature thermistor detected a temperature of less than 5
degrees for 1 sec., or more than 10 sec. after power on. However, if the thermistor
detected less than 100 degrees after measuring temperature at start up,
temperature is checked again after 50 sec.



298
Error Name/Error Condition/Major Cause/Solution
off/on.
Error Name/Error Condition/Major Cause/Solution
Glue level thermistor defective
Glue heater defective
Slave board defective
Reconnect the connector.
Replace the gluing unit.
Replace the slave board.
Error Name/Error Condition/Major Cause/Solution
Glue level thermistor defective
Glue heater defective
Slave board defective
Reconnect the connector.
Replace the gluing unit.
Replace the slave board.
Error Name/Error Condition/Major Cause/Solution
Glue abnormal temperature thermistor defective
Glue heater defective
Slave board defective