Ricoh Pro C7200S Troubleshooting Manual page 264

1.SC Codes
SC No. Level






SC No. Level
SC752- D Perfect Binder: Sub grip close position lag error
33
At the start of the sub grip open operation, the SG close sensor did not go OFF,
even after the SG motor had operated for 500 ms.









SC No. Level
SC752-34 D
SC No. Level
SC752- D Perfect Binder: Sub grip HP late error
35
While moving to the sub grip home position, the sub grip HP sensor did not go
ON, even though the sub grip motor had operated for 3000 ms.
260
Error Name/Error Condition/Major Cause/Solution
Reconnect the connector.
Replace the SG motor.
Replace the SG close sensor.
Replace the slave control board.
Replace the motor harness.
Replace the sensor harness.
Error Name/Error Condition/Major Cause/Solution
SG motor defective
SG close sensor defective
Harness connector loose, broken, defective
Reconnect the connector.
Replace the SG motor.
Replace the SG close sensor.
Replace the slave control board.
Replace the motor harness.
Replace the sensor harness.
Error Name/Error Condition/Major Cause/Solution
Perfect Binder: Sub grip sensor error
The SG open sensor and SG close sensor went ON at the same time.

SG open sensor defective

SG close sensor defective

Harness connector loose, broken, defective

Reconnect the connector.

Replace the SG open sensor.

Replace the SG close sensor.

Replace the slave control board.

Replace the sensor harness.
Error Name/Error Condition/Major Cause/Solution