Ricoh Pro C7200S Troubleshooting Manual page 154

1.SC Codes
SC No. Level


Check if the SC occurs (feed paper, open/close the doors, Input or Output check).
If the SC occurs again, do the following steps.Check if the SC reoccurs by cycling
the power after each step.
1.
2.
3.
4.
SC No. Level
SC700- D Scan Motor error (1-pass ADF)
07
Error signal detected while the motor is driven.




Check if the SC occurs (feed paper, open/close the doors, Input or Output check).
If the SC occurs again, do the following steps.Check if the SC reoccurs by cycling
the power after each step.
1.
2.
3.
4.
SC No. Level
SC700- D Exit Motor error (1-pass ADF)
09
Error signal detected while the motor is driven.




Check if the SC occurs (feed paper, open/close the doors, Input or Output check).
If the SC occurs again, do the following steps.Check if the SC reoccurs by cycling
the power after each step.
150
Error Name/Error Condition/Major Cause/Solution
Harness broken
Overload
Check the harness connection.
Replace the encoder harness.
Replace the Transport Motor.
Remove torn paper from the paper path, remove foreign objects from the
drive area, and check for motor/motor bracket deformation.
Error Name/Error Condition/Major Cause/Solution
Motor defective
Connecter disconnected
Harness broken
Overload
Check the harness connection.
Replace the encoder harness.
Replace the Scan Motor.
Remove torn paper from the paper path, remove foreign objects from the
drive area, and check for motor/motor bracket deformation.
Error Name/Error Condition/Major Cause/Solution
Motor defective
Connecter disconnected
Harness broken
Overload