Ricoh Pro C7200S Troubleshooting Manual page 216

1.SC Codes
SC No. Level






SC No. Level
SC750- D Perfect Binder: Cut end late error
65 

Cutter motor defective, Blade sensors 1 defective, disconnected, overload. Blade
is dull, not cutting efficiently.







SC No. Level
SC750- D Perfect Binder: Cut end lag error
66 

Cutter motor defective, Blade sensors 1 defective, disconnected, overload. Blade
is dull, not cutting efficiently.






212
Error Name/Error Condition/Major Cause/Solution
Reconnect the connector.
Replace the cutter motor.
Replace the blade sensors 1, 2.
Replace the cutter control board.
Replace the motor harness.
Replace the sensor harness.
Error Name/Error Condition/Major Cause/Solution
During movement from front to rear during cutting, blade sensor 1 did not go
ON after enough time had elapsed for the blade to move 61 mm.
During movement from front to rear during cutting, blade sensor 1 did not go
ON after 10 sec. had elapsed.
Reconnect the connector.
Replace the cutter motor.
Replace the blade sensors 1.
Replace the cutter control board.
Replace the motor harness.
Replace the sensor harness.
Replace the blade.
Error Name/Error Condition/Major Cause/Solution
During movement from rear to front during cutting, blade sensor 1 did not go
OFF after enough time had elapsed for the blade to move 61 mm.
During movement from rear to front during cutting, blade sensor 1 did not go
OFF after 10 sec. had elapsed.
Reconnect the connector.
Replace the cutter motor.
Replace the blade sensors 1.
Replace the cutter control board.
Replace the motor harness.
Replace the sensor harness.