Automatic Route Selection (F-Route) - NEC ASPILA EX Feature Manual

Automatic Route Selection (F-Route)

• Available
Description
Conditions
Default Setting
Programming
Aspila EX Software Manual
Automatic Route Selection (ARS) provides call routing and digit translation based on the digits a user
dials. ARS consists of look up tables that compare the dialled digits and decide which translation table
should be used. The decision can optionally be dependant on time and day of the week. The transla-
tion table will then delete and/or add digits select the trunk group and seize the outgoing trunk
(A.) Line keys, outgoing loop keys, outgoing trunk group keys, dialing 804+trunk group, dialing
805+trunk number, and abbreviated dial numbers assigned to a certain trunk group can all be
used to by-pass ARS.
ARS is not programmed.
• 11-09-01 : Trunk Access Code
Specify the single digit code used to access ARS (normally 9).
• 14-05-01 : Trunk Groups
Program trunks of the same carrier type into the same trunk group.
• 14-07-01 : Trunk Access Map Setup
Set up the Trunk Access Maps (1-200). This sets the access options for trunks.
• 15-06-01 : Trunk Access Map for Extensions
Assign Trunk Access Maps (1-200) to extensions.
• 44-01-01 : System Options for ARS/F-Route
Select whether the ARS/F-Route feature should use the time schedule (0=not used, 1=used).
• 44-02-01 : Dial Analysis Table for ARS/F-Route Access - Dial
Set the Dial digits for the Pre-Transaction Table for selecting ARS/F-Route (8 digits).
• 44-02-02 : Dial Analysis Table for ARS/F-Route Access - Service Type
Set the Service Type (0-3) for the Pre-Transaction Table for selecting ARS/F-Route.
• 44-02-03 : Dial Analysis Table for ARS/F-Route Access - Additional Data
If a Service Type is selected in Program 44-02-02, set the additional data, if required, for the
Pre-Transaction Table for selecting ARS/F-Route
• 44-02-04 : Dial Analysis Table for ARS/F-Route Access - Dial Tone Simulation
Determine if the Dial Tone Simulation is on (1) or off (0) for the Pre-Transaction Table for
selecting ARS/F-Route.
• 44-03-01 : Dial Analysis Extension Table - Dial
Set the Dial digits to be used for the Dial Extension Analyze Table.
• 44-03-02 : Dial Analysis Extension Table - Table Number
Select the ARS/R-Route table number (0-500) to be used for the Dial Extension Analyze
Table.
Automatic Route Selection (F-Route)
Aspila EX
Features 79