NEC ASPILA EX Feature Manual page 550

Program 14 : Trunk Basic Setup
14-02 : Analogue Trunk Data Setup
Item
No.
07 DP to DTMF Conversion Options
Determine how a user can convert a Dial Pulse (DP)
call to a DTMF call. For each trunk, set the type of
DP to DTMF conversion required. There are three
conversion options: Automatic (0), Automatic and
Manual (1), or Manual (2).
Automatic:
DP to DTMF conversion occurs automatically if the
extension user waits more than 10 seconds before
dialing the next digit.
Automatic and Manual:
DP to DTMF conversion occurs automatically if the
extension user waits more than 10 seconds before
dialing the next digit. In addition, the user can dial #
to switch a DP trunk to DTMF dialing.
Manual:
User can dial # to switch a DP trunk to DTMF dial-
ing
08 Answering condition
09 Busy Tone Detection
10 Caller ID
Enable or disable a trunk's ability to receive Caller
ID information.
11 Next Trunk in Rotary if No Dial Tone
Use this option to enable/disable the system's abil-
ity to skip over a trunk if dial tone is not detected.
This option pertains to calls placed using Loop
Keys, Speed Dial, ARS, Last Number Redial or
Save Number dialed. It does not pertain to line key
or Direct Trunk Access calls.
12 Detect Network Disconnect Signal
13 Trunk-to-Trunk Limitation
14 Loop Start/Ground Start
Conditions
544 Programming
Item
None
Input Data
0 - Automatic
1 - Automatic and Manual
2 - Manual
0- Polarity reversing
1- Polarity reversing
or timer
0- disable
1- enable
0- disable
1- enable
0- disable
1- enable
0- disable
1- enable
0- disable
1- enable
0=Loop Start
1=Ground Start
Related
Default
Program
2 21-01-03
0 21-01-03
0
0
0
0
0
0
Aspila EX Software Manual