Program 10 : System Configuration Setup
10-09 : DTMF and Dial Tone Circuit Setup
10-09 : DTMF and Dial Tone Circuit Setup
Level:
IN
Description
Input Data
0- Common use
1- Extension only
2- Trunk only
Conditions
Feature Cross Reference
438
Programming
•
Available.
Use Program 10-09 : DTMF and Dial Tone Circuit Setup to allocate the circuits on the NTCPU
PCBs for either DTMF receiving or dial tone detection. The NTCPU PCB has 16 circuits initially.
With additional DSPDBs installed, the system can provide a total of 64 circuits (32 + 32). These are
used as follows:
•
Extension
•
Trunk
tion
Circuit/Resource Number
Input Data
None
•
Central Office Calls, Placing
•
Direct Inward Dialing (DID)
•
Direct Inward System Access (DISA)
•
Tie Lines
Aspila EX
DTMF receiver for SLT
DTMF receiver for analogue trunks, dial tone & busy tone detec-
for analogue trunks
Circuit/Resource 01-08: 1 (Extension only)
Circuit/Resource 09-32: 2 (Trunk only)
Circuit/Resource 33-64: 0 (Common use)
01-64
Default Setting
Aspila EX Software Manual