NEC ASPILA EX Feature Manual page 159

Programming
Related Features
Aspila EX Software Manual
• 11-01-01 : System Numbering
Set up a Service Code for Alternate Trunk Route Access.
• 11-09-01 : Trunk Access Code
If required, change the Trunk Access Code (normally 9).
• 11-09-02 : Trunk Access Code - Alternate Trunk Route Access Code
Assign the Service Code set up in 11-01 for Alternate Trunk Route Access.
• 14-05-01 : Trunk Groups
Assign trunks to trunk groups (1-100).
• 14-06-01 : Trunk Group Routing
Set up an outbound routing table (1-100) for trunk groups assigned in Program 14-05.
• 14-07-01 : Trunk Access Map Setup
Access Map programming may limit Trunk Group Routing options.
• 15-06-01 : Trunk Access Map for Extensions
Access Map programming may limit Trunk Group Routing options.
• 15-07-01 : Programming Function Keys
Assign a data key (code 66) to each system phone with a data module installed.
• 20-06-01 : Class of Service for Extensions
Assign Class of Service (1-15) to extensions.
Computer Telephony Integration (CTI) Applications
CTI applications automate the office with TAPI compatibility and external PC control.
Hotel/Motel, inDepth/inDepth+
These features require the use of a CTA or CTU module.
Prime Line Selection
Do not set up Prime Line Selection for extensions with Telemarketing Dial.
Programmable Function Keys
A system phone with a Data Module must have a data key. Optionally, system phones can
also have Telemarketing Dial keys.
Single Line Telephones
Single line telephones cannot use the Data Communications capabilities of the system. Check
this feature for further programming.
Station Message Detail Recording
The system uses CTA and CTU modules for SMDR and system reports.
TAPI Compatibility
The system has Telephony Programming Applications Interface (TAPI) capability.
Traffic Management Report (TMS)
Systems use CTA and CTU modules for the Traffic Management Reports.
Data Communications
Features 145