Single Line Telephones, Analogue Sets - NEC ASPILA EX Feature Manual

Single Line Telephones, Analogue Sets

• Available - 256 single line telephones maximum.
Description
Conditions
Default Setting
Programming
Aspila EX Software Manual
Single Line Telephones, Analogue Sets
The system is compatible with Dial Pulse and DTMF analogue single line telephones (SLTs). You
can install single line telephones as On-Premise or Off-Premise extensions. Single line telephone
users can dial codes to access many of the features available to system phone users. With Single
Line Telephones, you can have your system simulate PBX type operation.
When installing single line telephones, you must have:
• A port on an SLIU PCB for each single line telephone installed.
• (If you have DTMF telephones) At least one block reserved on the NTCPU for analogue
extension DTMF reception.
(A.) Dial Pulse single line telephones cannot access any features that require the user to dial # or *.
• Single Line Telephones function as soon as they are installed and properly programmed.
•10-03-01 : PCB Setup
Program all on-premise type single line telephones with circuit type 2.
•10-03-03 : PCB Setup, For SLIU Unit - Transmit CODEC Gain Type
10-03-04 : PCB Setup, For SLIU Unit - Receive CODEC Gain Type
Assign transmit and receive levels for single line telephones.
•10-09-01 : DTMF and Dial Tone Circuit Setup
If the system has DTMF single line extensions, allocate at least one circuit for analogue exten-
sion DTMF reception (entry 0 or 1).
• Use the following as a guide when allocating DTMF receivers:
- In light traffic sites, allocate one DTMF receiver for every 10 devices that use them.
- In heavy traffic sites, allocate one DTMF receiver for every five devices that use them.
•15-03-01 : Single Line Telephone Basic Data Setup - SLT Signaling Type
Enter 0 if single line phone is dial pulse. Enter 1 if single line telephone is DTMF.
•15-03-03 : Single Line Telephone Basic Data Setup - Terminal Type
Enter 0 for normal single line telephones. Enter 1 if a Voice Mail port (refer to "Voice Mail"
for more).
•20-03-02 : System Options for Single Line Telephones - Ignore Received DP Dial on DTMF
SLT Port
Use this option to define whether the system should receive dial pulse and DTMF signals (0)
or ignore dial pulse and only accept DTMF signals (1).
•20-13-13 : Class of Service Options (Supplementary Service) - Continued Dialing
Set option to '0' to prevent dual DTMF tones when using Continued Dialing.
•80-03-01 : DTMF Tone Receiver Setup
80-04-01 : Call Progress Tone Detector Setup
Aspila EX
Features 327