NEC ASPILA EX Feature Manual page 415

How to Exit the Programming Mode
Aspila EX Software Manual
To exit the programming mode:
When you are done programming, you must be out of a program's options to exit (pressing the
MSG key will exit the program's option).
1. Press MSG key to exit the program's options, if needed.
Program Mode
Base Service OP1 OP2
2. Press SPK. You see, "Saving System Data" if changes to were to the system's programming.
3. The display shows "Complete Data Save" when completed and will exit the phone to an idle
mode.
To save a customer's database, a blank PC-ATA card is required. Insert the card into
the NTCPU and, using Program 90-03, save the software to the PC-ATA card. (Program
90-04 is used to reload the customer data if necessary.) Note that a PC-ATA card can only
hold one customer database. Each database to be saved will require its own separate
card.
Introduction to Programming
Before You Start Programming
Programming 409