Honda CBR600F4i Series Service Manual page 92

A th
iv~
r . : 11aiH
wfr/)
a cfio-rype
-nasrer
/,nk mus t not be
l.JSttc.f.
Make sure the pins are staked prope rly by mcosuring
the diameter of the staked area usinR a sl i de caliper.
DIAMETER OF THE STAKED AREA:
DID: 5.50 - 5.80 mm (0.217 - 0.228 i n)
RK: 5.55 - 5.85 mm (0.219 - 0.230 i n)
Alle r slaking, check the staked area of the master link
tor cr11cks.
If there is any cracking, replace the master link,
0-
rin!Js and plale.
BRAKE FLUID
NOTICE
Do not mix rliff P.rP.nt types of fluirl,
FIS
thP.y flrP. not
compotiblc with each orher.
Do not
allow foreign macerial tu entlc!r the
system
when filling the reservoir.
Avoid spilling fluid on poinred, plastic or rubber
pans. Place a rag over these pans whenever the
system is serviced.
W hen the fluid level is low. check the brake pads for
wear (see nexl page). A low fluid level m ay be d ue to
we,H ot thP. hrakP.
plHiS.
It t he hrnkP.
f)llOS
FHP. worn,
the colipcr piston is pushed out, and th is accounts for
a low reservoir level. II t he brake pads are not worn
and the fluid levP.I is low, chP.r.k thP. P.ntire systP.m for
leaks (sec next pogcl.
FRONT BRAKE
Tu rn the handlebar so the reservoir is level and check
the front brake fluid reservoir level.
If the level is near the lower level line. check brake pad
wear (see next page).
REAR BRAKE
Place the m otorcycle on a level su rface and support it
in an ur,right position.
Check the rear brake fluid reservoir level.
If the level is near l ite lower level line, d1eck brake pad
WP.ilr {SP.P. nP.xt flilQP.).
MAINTENANCE
GOOD
NO GOOD
CRACKED
LOWER LEVEL LINE
3-23