Honda CBR600F4i Series Service Manual page 127

FUEL SYSTEM (Programmed Fuel Injection)
PGM-FI MIL 2 BLINKS (MAP SENSOR)
Turn thP. ignition switch to "OFF" .
Disconnect the vacuum hose fro m the MAP sen -
sor
Connect the vocuum gouge between the throttle
body and the MAP sensor using a 3-way joint.
Start the engine and measure the manifold
absolute pressure at idle speed.
:i~~ \ . -~
,:--"'j
,i~~~~~~')
~t,;t - ~
,_' l ,.J,,: '
,/ ,,:r,~~;;,-~.
-~<;~,
1
· ·
~~i-
~~;~n ,~~~~~~- ~
""«., ' '\,, . .,.,
J
Standard: 150 - 250 mm Hg
Disconnect the vacuum gauge and co nnect the
hose to the MAP sensor.
L
Disconnect the ECM connector3.
Connect the lest harness to the ECM connector.
5-14
Out of range
• Check hose installation.