Honda CBR600F4i Series Service Manual page 125

FUEL SYSTEM (Programmed Fuel Injection)
PGM-FI MIL 1 BLINK (MAP SENSOR)
Turn the ignition swild1 L u "OFF".
Disconnect the MAP sensor 3P connector.
Check fur loose or poor contact on the MAP sen-
sor c.onnecto r.
Connec.t the MAP sensor connector.
Place the m oto rcyc le on its side stand.
Start the eng ine and check that the MIL blinks.
1 b link
Turn the ign1 t1on switch to "OFF" .
Discon11t1cl the MAP sensor 3P connector.
Tu rn the ignition swit ch to "ON".
Measure t he vo ltuge at the wire harness sirle
cunnector.
Vnltage exists
Does not bl i nks
Out of ra nge
Out of range
Measure the voltage between the connecto r Ler-
t--------- -
minals of the wire harness side.
~
; ¥~·
1
r ·
Connection: Yellow/Red
(+) -
Green/Orange
1-)
Standard:
4.75 - 5.25 V
Voltage exists
5-12
Loose or poor contact on the MAP sensor connec•
tor.
Open or short circuit in Yellow/Red wire.
louse or poor contact on the ECM connectors.
Open or short ci rcuit in Green/Orange
wi re.
Loose or poor contact on the ECM c.:u1111t1c.:lurs.