Honda CBR600F4i Series Service Manual page 475

Always replace
!h&
sealing wash-
er with a new
one.
lnstDII ond t ighten the ECT/thermo sensor tto the SJ.Jec-
ified torque.
TORQUE: 23 N·m 12.3 kgf•m, 17 lbf.ft)
Connect the ECT/th ermo sensor conner.tor.
Fi ll the system ond bleed the air (pas:,e.6-4 ).
COOLING FAN MOTOR SWITCH
INSPECTION
Remove the following:
- Seat (page 2-2)
- Lower cowl (J.Jage 2-4)
Check for a blown fuse before inspectiu11.
Fan motor does not stop
Tu rn t he ignition switch t o "OFF", disconnect the cu11-
ncctor from the fan motor swi tch and t urn the ignition
switch
lo
"ON " again.
If the fa n moto r does not stuJ.J, check for a shorted
w i re between t he fan motor a nd switr.h.
If th e fan motor stops, replace the ton motor switch.
Fan motor does not start
Before t esting, wArm up the engine to operating tem -
perature.
Disconnect the connect or from the fan motor switch
and ground the connecto r t o the body with a jumper
w ire.
Turn the ignition switch to " ON" and check the fan
motor.
If the motor starts, check the connection 11t the fan
motor switch termi nal.
If it is OK, rcp locc the fan motor switch.
LIGHTS/ METERS/SWITCHES
\
.
'-'
.
\ ECT/THERMO SENSOR CONNECTOR
' -
....
FAN MOl OR SWITCH
CONNECTOR
19-15