Honda CBR600F4i Series Service Manual page 314

Instal l th e lower crankcase onto the upper crankcase.
Clean the new t:rankcase 8-rnrn bolls th or oughly w ith
solvent and blow them dry.
Apply o il to the 8 mm bolt threads and seating sur-
face, and install them.
Install th e 10-mm bolt, six 7-m m bolts an d two 6-m m
bolts.
Make sure the upper and lower crankcases are sealed
securely.
From the inside to out side, tii;ihten t he lower
crankcase 8-mm bolts (m ai n journal bolts) in
a
criss-
cross pattern in two or th ree steps.
TORQUE: 25 N •rn (2.6 kgf•m, 19 !bf.ft)
Tighten the 10-mm bolt t o the specified t orque. and
th en t ight en 7-mm bolts and 6-mm bo lts.
TORQUE: 10-mm bolt: 39 N•m 1 4.0 kgf•m, 29 lbf-ft l
7-mm bolt: 18 N•m (1.8 kgf•m , 13 lbf-ft)
TM
see/mg
wash-
Insta ll t he upper crankcase five 8-mm bolts and seven
e, locaiions are
6 mm bolts with new sea ling washers.
indicated on rhe
ripper crankc.ase
using t/Je
"il"
mark.
Tighten the
A-mm
bolts i n a crisscross pa ttern in two
or th ree steps.
TORQUE: 25 N•m (2.5 kgf•m, 18 !bf.ft)
Tig hten the 6-mm bolts in a crisscross pattern i n two
or t hree steps secu rely.
CRANKCASE/ TRANSMISSION
7
mm
BOLTS
8 mm BOLTS
6mm
BO LTS
10
m m
BOLTS
~.,
6 mm BO LT/ "-illll' SEALING WASHER
6 mm BOLTS
A m m BOLTS/
~
Sl:ALING WASHERS
11-13