Honda CBR600F4i Series Service Manual page 477

Short the oil pressur<:l 'Switch wire terminal with the
ground ui;ing a jumper wore.
The oil pressure warning indicator comes on with the
ignition switch turned to "ON".
If the li ght do<:ls not co m e on. r.he.ck the sub-fuse (1 OA)
amJ
wires for a loose connection or an open circuit.
Stort the engine and make sure the. hght goes out.
If the liyhl does not go out, check the oil pressure
{page 4-~).
If the oil pressure is normal, replace the oil pressure
switch (see IJ<:llow).
REMOVAL/ INSTALLATION
Remove th"' boot. te rmin11 I screw ond w ire t erminal
(see previou5 page).
Hemove the oil pressure switch from the
crankr.t1se.
Aµp ly sealant to the oi l pressu re switch t hreads as
shown.
Insta ll th e oil pressure sw itch onto the r.rimkcase,
tighten it to
Lile
specified torque.
TORQUE: 12 N•m (1.2 kgf•m, 9 lbf•fl)
Connect the oil presiwre switch tcrmin31 to the switch
and tighten the screw to the specified tu,que.
TORQUE: 2 N•m (0 .2 lcgf•m, 1.4 lbf.ftl
Install the dust cover.
FUEL RESERVE SENSOR
INSPECTION
Turn the ignition switch to "ON" c1nd m ake
sure
the
fuel reserve indicator comes on.
If the fuel reserve indicator doei; nul indicate p roper-
ly. check for t he following.
Oisr.onnect the fuel reserve sensor 3P (Black) connec-
tor.
Short the wire harness side connector Brown/Black
and Green/1:ll ack terminols with a jumper wire.
LIGHTS/ METERS/ SWITCHES
1r-)
I
Do not apply seala nt to the thread
heed 3 4 mm {0.1 - 0.2 in).
..
◄
TERMI NAL
SCREW
JUMPER WIRE
19-17