Honda CBR600F4i Series Service Manual page 309

CRANKCASE/TRANSMISSION
!nsta.'I '.,Vo'lh tho
groove side feci,1g
up.
11-8
Measure the mainshaft O.D. at the M5 gear.
SERVICE LIM IT: 24.96 mm (0.983 in )
Measure the countershaft O.D. at the C2 gear.
SERVICE LIMIT: 27.96 mm (1.101 in )
Calcu late the gear bushing-to-shaft de11ranc.e.
SERVICE LIMITS:
MS: 0.06 mm (0.002 in)
C2: 0.06 mm (0.002 in )
Turn the outer race of each bearing with your fing er.
The bea ri ngs shou ld tu rn smoothly and quietly.
Also check that the bearing inner , ace fils liyhlly on
th e shaft.
Remove and d iscard the mai nshaft bearing if t he race
does not turn smoothly, quietly, or fits loosely on the
mainshaft.
Replace the countershaft, co ll ar, ond bea ring as an
assembl y ii
the
race does not turn smoothly, quietly,
or tits loosely on the countershaft.
MAINSHAFT BEARING REPLACEMENT
Press out the mainshaft from the bearing usi ng a
hydraulic p ress.
Install a new mainshilft bearing onto the mainshaft by
pressi ng the mainshaft bcoring inner race using the
special tools.
TOOLS:
Inner driver C
Attachment, 25 mm I.D.
07746-0030100
077 46--0030200
Et
C2
MAINS HAFT
l"1 DRIVER,
40 mm I.D.
~