Honda CBR600F4i Series Service Manual page 231

ENGINE REMOVAL / INSTALLATION
Remove the rear engine hanger bolt and distance cul-
lor, then remove the eng ine from t he frame.
ENGINE INST ALLA Tl ON
7-10
Note the direction of the hanger bolts.
Whe11 Lightening the lock nut with the lock nut
wr1rnr.h, refer to torq ue wrench readi ng info, ma Liu11
on poge 7-2 "SERVICE INFORMATION".
The jack height must be continually adjusted to
relieve st ress
from
t he mounting rc1ste11ers.
Route the wire and cables properly (page 1-23).
NOTICE '
Be su, e iv liyhle11 all engine mouming fasteners to
the spP.cifiP-ri torque in the specified sequ&nL"e
described folfowing page.
If
you make
fl
mistflkP. dur-
iny llie tighteninq rorque or sequence, loosen o/1
mounting fasteners, then tighten lhel/1 c1yain to the
specified torque in the specd1P.ri sP.q11ence.
Install the engine hange, c1tljusling bolts fully in from
the inside of thP. f r11me.
Careful ly instoll the engine into the frame.
ln~tflll the left side of the center hanger bull.
L_
CENTER HANGER BOLT