Honda CBR600F4i Series Service Manual page 197

FUEL SYSTEM (Programmed Fuel Injection )
Do nor
diSCO/lll&CI
the bvnk angle
sensor connector
during inspecrion.
'"stall me ba()k
ang.'e s~n.' w r with
tJ!>
''UP" 1muk fac-
i'ig
U,0.
5-84
Turn the ignition switch t o "OFF".
R!elrnove the screws and bank ang le sensor.
Place the bank ang le sensor horizontal as shown, and
turn the ignition switc h to "ON".
Thre l>a11k a11yl!e1 se 11sur is normal if the engine stop
relay d ic.k~ ;,nn rowP. r ~11rrly is c.losP.r1.
Incli ne the bank an9le sensor approximately 60
degrees to the left or right with the ignition switch
turned to "ON".
The bank angle sensor is normal if the engine s1op
relay cl icks and powe r supply is open.
If you repeat t his test, first turn th e ignition switch to
" OFF", then turn the i9nition switch to "ON".
REMOVAL/ INSTALLATION
nisconnect the bank ang le senso r 3P (Green) connec•
tor.
Remove the two screws, nuts and bank angle sensor.
Installation is i n the reve rse o rder of removal.
Tig hten the m ounting screws securely.
60" BANK ANG LE POSITION
~ ~
~ j
----4'
NORMAL (approxi m ately)
60. ,· ..
~
.·, 60'
POSITION
(;;pproximat P.ly)
CONNECTOR