Honda CBR600F4i Series Service Manual page 234

Inst.ill ond tighten the right side center ha n!'.]er bolt to
the specified torque.
TORQUE: 39 N·m (4.0 kgf•m, 29 lbMt)
Fully install t he rear engine hangP.r bo lt.
Install and tight en the rear engine hanger nut t o the
specified torque.
TORQUE: 39 N•m (4.0 kgf•m, 29 lbMt)
Install the swingarm between the enginP. and trnme,
install and t ighten the pivot components (page 14-22).
Install the drive sµrocket with the drive chai n onto the
co untershaft with thP. "MT4F" mark facing out.
Inst all the wosher and bolt, tighten the bolt to the
specified torque .
TORQUE: 54 N·m (5.5 kgf•m, 40 lbf-ft)
Connect the clutch cable to the clutch li fter lever.
Install the clutch cable guide to t he right crankcase
cover and tighten the mounting bolts securely.
Install the cam chain tensioner lifter onto the cylinder
head.
Instal l the seal ing washers and bolts. tigh ten the bolts
to the specified torque.
TORQUE: 10 N•m (1.0 l<gf•m. 7 lbMt)
ENGINE REMOVAL/ INSTALLATION
CLUTCH CABLE CABLE GUIDE
r
l
~
kJFTER LEVER
SOCKET BOLTS
SEALING WASHERS
7-13