Diagnostics Via Starter; Diagnostic Functions - Siemens SINAMICS Series Operating Instructions Manual

Descriptions of functions
10.34 Diagnostics
LED Color
OPT -
(OPTION)
Green
Red
RDY and Red
DP1
RDY and Orange
OPT
MOD -
10.34.5

Diagnostics via STARTER

The diagnostic functions support commissioning and service personnel during
commissioning, troubleshooting, diagnostics and service activities.
Requirement
● Online operation of the STARTER commissioning tool.

Diagnostic functions

The following diagnostic functions are available in the STARTER commissioning tool:
● Specification of signals with the ramp-function generator
● Signal recording with the trace function
● Analysis of the control response with the measuring function
638
State Description, cause
Off Electronic power supply is missing or outside
permissible tolerance range,
Component not ready for operation,
Option Board not installed,
No associated drive object has been created
Continuous Option Board is ready for operation.
light
Flashing light Depends on the Option Board used
0.5 Hz
Flashing light At least one fault is present in this component.
2 Hz
Option board not ready (e.g. after switching on)
Flashing light Bus fault – communication has been interrupted
2 Hz
Flashing light The firmware of the connected CBE20
0.5 Hz Communication Board Ethernet is being updated
Off Reserved
Remedy
Check power supply
and/or component
-
-
Remedy and acknowledge
fault
Correct fault
-
-
SINAMICS DCM DC Converter
Operating Instructions, 12/2018, A5E34763375A