Optimization Runs; Status After Commissioning - Siemens SINAMICS Series Operating Instructions Manual

Hide thumbs Also See for SINAMICS Series:

Table of Contents

Commissioning

8.4 Commissioning using the AOP30 operator panel

Optimization runs

Perform the optimization runs one after the other:

To navigate through the selection fields, choose <F2> or <F3>.

To activate a selection, choose <F5>.

For further details, see Chapter "Drive optimization (Page 336)".

If an optimization run is not carried out, the motor control uses the motor characteristic

values calculated from the rating plate data rather than the measured values.

Unexpected motor movement during optimization runs

Optimization runs cause movement of the drive which can result in death, severe injury or

material damage.

• Observe the general safety instructions.

• Ensure that the EMERGENCY STOP functions are fully functional when commissioning

LOCAL mode (control via operator panel)

● You switch to LOCAL mode by pressing the "LOCAL/REMOTE" key.

● Control (ON/OFF) is carried out via the "ON" and "OFF" keys.

● You can set the setpoint using the "Increase" and "Decrease" keys or by entering the

appropriate numbers on the operation screen using the numeric keypad.

Optimization of the armature current control for induction load

Optimization of the field current control

Optimization of the armature current control

Optimization of the speed control

Optimization of the EMF control (incl. field characteristic recording)

Recording of the friction characteristic

Optimization of the speed control for drives with a mechanical system capa-

ble of oscillation

SINAMICS DCM DC Converter

Operating Instructions, 12/2018, A5E34763375A