Siemens SINAMICS Series Operating Instructions Manual page 337

Hide thumbs Also See for SINAMICS Series:

Table of Contents

You can also subsequently activate option module CBE20.

● Start the configuration wizard via "Control Unit" -> Configuration" -> "Wizard..."

● In the "Option module" screen form, select CBE20

● Work through the remainder of the wizard up to the end

● Load the project to the drive

Deleting from the drive online

Removing a CBE20 without STARTER always leads to the loss of the parameter

assignments which are replaced by the factory settings.

(recent commissioning)

Deleting offline with STARTER

CBE20 can only be removed in the offline state.

● Start the configuration wizard via "Control Unit" -> Configuration" -> "Wizard..."

● In the "Option module" screen form, deselect CBE20

● Work through the remainder of the wizard up to the end

● Remove the CBE20 option board from the Control Unit

● Load the project to the drive

SINAMICS DCM DC Converter

Operating Instructions, 12/2018, A5E34763375A

8.7 Commissioning optional additional modules

Commissioning