Siemens SINAMICS Series Operating Instructions Manual page 110

Hide thumbs Also See for SINAMICS Series:

Table of Contents

6.2 Cable routing into the unit

For units with a rated DC current ≤280 A, the PROFINET and DRIVE-CLiQ cables must be

routed into the unit from the top (PROFINET is only available with Communication Board(s)

Connection for the electronic power supply (XP1). Mechanically attach the cable using one of the

shield clamps

at the side of the enclosure. Two holes on the printed-circuit board to attach

the cable using cable ties.

Connection for the analog tachometer (XT1) Connect the shield to one of the shield clamps

on the side of the enclosure.

Connection for E-STOP (XS1). Route the cable into the device from the bottom.

Connection for the floating relay output for the line contactor (XR1). Route the cable into the

device from the bottom.

Cable routing, power interface

SINAMICS DCM DC Converter

Operating Instructions, 12/2018, A5E34763375A