Parallel Connection - Siemens SINAMICS Series Operating Instructions Manual

Parallel connection

Up to 31 drives receive the same setpoints from drive 1.
1) The shields for the interface cables must be connected directly on the devices (using a clamp, for example) to device
or cabinet ground, with a low level of impedance.
2) Twisted cable, e.g. LIYCY 2×0.5 mm
that the difference in ground potentials between the link partners remains below 7 V.
Figure 10-87 "Parallel connection" peer connection type
SINAMICS DCM DC Converter
Operating Instructions, 12/2018, A5E34763375A
; with longer cables, an equipotential bonding cable should be used to ensure
2
10.30 Serial interface with peer-to-peer protocol
Descriptions of functions
627