Siemens SINAMICS Series Operating Instructions Manual page 320

Commissioning
8.5 Commissioning with the STARTER commissioning tool
Transferring a STARTER project to the drive unit
The following steps are required to transfer the STARTER project created offline to the drive
unit:
● Step 1
Select the menu command Project > Connect to target system
Selection in the toolbar:
● Step 2
Select DCM_ADVANCED_CUD as drive unit in the following screen and confirm with OK:
Figure 8-31
318
Target device selection
SINAMICS DCM DC Converter
Operating Instructions, 12/2018, A5E34763375A