Resetting Parameters To Factory Settings; Commissioning With The Starter Commissioning Tool - Siemens SINAMICS Series Operating Instructions Manual

Hide thumbs Also See for SINAMICS Series:

Table of Contents

Resetting parameters to factory settings

The factory settings represent the defined original status of the device on delivery.

Resetting the parameters to the factory settings means that all the parameter settings made

since the system was delivered are reset.

Setting the parameter filter to "Parameter reset"

<MENU> <Commissioning/Service> <OK> <Device commissioning> <OK> <30: Parameter

Restoring all parameters to their factory settings

All of the unit parameters are reset to their factory settings. The AOP30 is powered down

and back up again during this process.

STARTER commissioning tool

You can use the STARTER commissioning tool to configure and commission your

SINAMICS drives or drive systems. The drive configuration can be performed with the aid of

the STARTER wizard for drive configuration.

This chapter described how to commission with STARTER. STARTER has a comprehensive

online help that explains in detail all of the sequences and setting options in the system. This

is the reason that this chapter is restricted to the individual commissioning steps.

Prerequisites for installing STARTER

STARTER is installed on a PG / PC. The hardware and software preconditions are described

in the readme file for STARTER.

The SIMOTION SCOUT engineering tool includes the STARTER functionality to commission

From version V4.2, SCOUT has also been released for commissioning SINAMICS DCM.

SINAMICS DCM DC Converter

Operating Instructions, 12/2018, A5E34763375A

8.5 Commissioning with the STARTER commissioning tool

Commissioning