Siemens SINAMICS Series Operating Instructions Manual page 296

Commissioning
8.5 Commissioning with the STARTER commissioning tool
Figure 8-11
Note
PG/PC is the only master on bus must be activated if no other masters (PC, S7, etc.) are
available on the bus.
Note
Even if no PROFIBUS interface is installed in the PC, projects can be generated and
PROFIBUS addresses for the drive objects can be assigned.
Only the bus addresses available in the project will be offered. That prevents double bus
address assignments.
When required, a manual address entry can also be used to enter an already assigned
address.
⇒ After completion, click OK to confirm the setup and to return to the project wizard.
294
Setting the interface – Properties
SINAMICS DCM DC Converter
Operating Instructions, 12/2018, A5E34763375A