Siemens SINAMICS Series Operating Instructions Manual page 691

Hide thumbs Also See for SINAMICS Series:

Table of Contents

The electronic power supply must not be interrupted during the firmware update, otherwise

the update will need to be restarted.

To safely remove the memory card, see Chapter "Memory card functions (Page 359)".

Step 3: Update the STARTER project

Install the SSP that matches the new firmware version (e.g. SSP SINAMICS DCP V1.2).

SSPs for different versions of the same drive can be simultaneously installed in STARTER.

Open the existing STARTER project (that refers to an old device version). Right-click the

device in the project navigator and select "Target device" → "Device version...". Select the

new device version and confirm with "Change version". The project is converted to the new

device version.

STARTER does not support a "downgrade" of the firmware version (e.g. V1.2 to V1.1).

Step 4: Load into the target system, RAM to ROM

Load the project into the drive (load into the target system) and permanently save the

parameter assignment (carry out RAM to ROM).

SINAMICS DCM DC Converter

Operating Instructions, 12/2018, A5E34763375A

11.1 Upgrading firmware releases