Configuring And Commissioning - Siemens SINAMICS Series Operating Instructions Manual

Hide thumbs Also See for SINAMICS Series:

Table of Contents

● The ports of the CBE20 must be interconnected strictly in accordance with the previous

diagram. You must always connect port 2 (P2) of node n with port 1 (P1) of node n + 1.

● In the "SINAMICS Link" mode, ports 3 and 4 of the CBE20 can only be used to connect to

the STARTER commissioning tool or Startdrive.

Corresponding parameters for IF1 or IF2

Use different parameters for configuring, depending on which interface SINAMICS Link is

Table 10- 41 Corresponding parameters

Setting of the processing mode for PROFIdrive STW1.10 "Control by PLC".

Connector output to interconnect the PZD (setpoints) received from the fieldbus

controller in the word format.

Selects the PZD (actual values) to be sent to the fieldbus controller in the word

Displays the PZD (actual values) sent to the fieldbus controller in the word

Connector output to interconnect the PZD (setpoints) received from the fieldbus

controller in the double word format.

Selects the PZD (actual values) to be sent to the fieldbus controller in the

double word format.

Displays the PZD (actual values) sent to the fieldbus controller in the double

word format.

Configuring and commissioning

When using SINAMICS Link, the memory card must remain inserted in the CUD.

p8835 cannot be set to 3 if it is not inserted.

Commissioning

When commissioning, proceed as follows:

1. Set the Control Unit parameter p0009 = 1 (device configuration).

2. Set the Control Unit parameter p8835 = 3 (SINAMICS Link).

3. Using p8839, define which interface should be used (for example for IF1: p8839[0] = 2).

SINAMICS DCM DC Converter

Operating Instructions, 12/2018, A5E34763375A

Descriptions of functions

10.6 Communication via SINAMICS Link