Control Panel - Display; Control Panel - Leds; Control Panel - Control Keys - Danfoss VLT AutomationDrive FC 300 Design Manual

FC 300 Design Guide

Control Panel - Display

"
The LCD display has back lighting and a total of 6 alpha-numeric lines. The display lines show the direction of
rotation (arrow), the chosen Set-up as well as the programming Set-up. The display is divided into 3 sections:
Top section shows up to 2 measurements
in normal operating status.
The top line in the Middle section
5 measurements with related unit, regardless of
status (except in the case of alarm/warning).
Bottom section always shows the state of the
adjustable frequency drive in Status mode.
The Active Set-up (selected as the Active Set-up in par. 0-10) is shown. When programming a Set-up
other than the Active Set-up, the number of the programmed Set-up appears to the right.

Control Panel - LEDs

"
In the lower left corner of the control panel, three
LEDs are located: A red alarm LED, a yellow
warning LED, and a green voltage LED.
If certain threshold values are exceeded, the alarm and/or warning LED light(s) up. A
status and alarm text appear on the control panel.
The voltage LED is activated when the adjustable frequency drive receives voltage or 24 V
external supply. At the same time, the back light is on.

Control Panel - Control Keys

"
The control keys are divided into functions. The
keys below the display and indicator lamps are
used for parameter Set-up, including choice of
display indication during normal operation.
Keys for local control are found at the bottom
of the control panel.
122
How to Program
shows up to
MG.33.B3.22 - VLT is a registered Danfoss trademark
Top section
Middle section
Bottom section
130BP046.10
130BP045.10