Parameter Set-Up; Quick Menu Key Functions - Danfoss VLT AutomationDrive FC 300 Design Manual

FC 300 Design Guide
Status screen II:
See the operating variables (1.1, 1.2, 1.3, and 2)
shown in the screen in this illustration.
In the example, Speed, Motor current, Motor
power and Frequency are selected as variables
in the first and second lines.
Status screen III:
This state displays the event and action of the
Smart Logic Controller. For further information,
see section Smart Logic Controller.

Parameter Set-Up

"
The FC 300 Series can be used for practically all assignments, which requires the appropriate number of pa-
rameters. The series offers a choice between two programming modes - a Main Menu and a Quick Menu mode.
The former provides access to all parameters. The latter takes the user through a few parameters
making it possible to start operating the adjustable frequency drive.
Regardless of the mode of programming, it is possible to change a parameter both in
the Main Menu mode and in the Quick Menu mode.

Quick Menu Key Functions

"
Pressing [Quick Menus] display this readout.
The list indicates the different areas contained
in the Quick menu.
Select My Personal Menu to display the chosen
personal parameters. Select these parameters
are selected par. 0-25 Personal Menu. Up to 20
different parameters can be used in this menu.
Select Quick setup to go through a limited
amount of parameters to get the motor running
almost optimally. The default setting for
the other parameters considers the desired
control functions and the configuration of signal
inputs/outputs (control terminals).
The selection of parameter is effected by means
of the arrow keys. The parameters in the
table to the right are accessible.
126
How to Program
MG.33.B3.22 - VLT is a registered Danfoss trademark
1.1
Pos.: No.: Parameter:
1 0-01 Language
2 1-20 Motor power
3 1-22 Motor voltage
4 1-23 Motor frequency
5 1-24 Motor current
6 3-02 Minimum reference
7 3-03 Maximum reference
8 3-41 Ramp 1 ramp up time
9 3-42 Ramp 1 ramp down time
10 3-13 Reference site
1.3
1.2
2
Unit:
[kW]
[V]
[Hz]
[A]
[rpm]
[rpm]
[sec.]
[sec.]