Danfoss VLT AutomationDrive FC 300 Design Manual page 138

FC 300 Design Guide
0-25 My Personal Menu
Array [20]
Range:
0 - 9999
Function:
Defines the parameters to include in the Q1 Personal
Menu accessible via [Quick Menu] on the LCP. Add
up to 20 parameters in the Q1 Personal Menu.
The parameters are listed in the Q1 Personal Menu
in the order programmed in this array parameter.
Delete parameters by setting the value to "0000".
0-4* LCP Keypad
"
0-40 [Hand on] Key on LCP
Option:
Disabled
*
Enabled
Password
Function:
Select Disabled [0] to avoid accidental start of
the drive in Hand mode. Select Password [2]
to avoid unauthorized start in Hand mode. Set
the password in par. 0-62 or par. 0-64 if par.
0-40 is included in the Quick menu.
0-41 [Off] Key on LCP
Option:
Disabled
*
Enabled
Password
Function:
Press [Off] and select Disabled [0] to avoid
accidental drive stop. Press [Off] and select
Password [2] to avoid unauthorized stop. Set
the password in par. 0-62 or par. 0-64 if par.
0-40 is included in the Quick menu.
0-42 [Auto on] Key on LCP
Option:
Disabled
*
Enabled
Password
Function:
Press [Auto on] and select Disabled [0] to avoid
accidental drive start in Auto mode. Press [Auto on]
default setting ( ) display text
*
138
How to Program
and select Password [2] to avoid unauthorized start
in Auto mode. Set the password in par. 0-62 or par.
0-64 if par. 0-40 is included in the Quick menu.
*
Press [Reset] and select Disabled [0] to avoid
accidental alarm reset. Press [Reset] and select
Password [2] to avoid unauthorized resetting. Set
the password in par. 0-62 or par. 0-64 if par.
0-40 is included in the Quick menu.
0-5* Copy / Save
"
[0]
[1]
*
[2]
Select Transfer to LCP all parameters [1] to copy all
parameters in all set-ups from the drive memory
to the LCP memory. Select Transfer from LCP all
parameters [2] to copy all parameters in all set-ups
[0]
from the LCP memory to the drive memory. Select
[1] Transfer from LCP size indep. parameters [3] to
[2]
copy only the parameters that are independent of
the motor size. The latter selection can be used
to program several drives with the same function
without disturbing motor data which are already set.
*
[0]
[1]
[2]
Select Copy to set-up 1 [1] to copy all parameters
in the currently edited set-up (set in par. 0-11)
[ ] value for use in communication via serial communication port
MG.33.B3.22 - VLT is a registered Danfoss trademark
0-43 [Reset] Key on LCP
Option:
Disabled
Enabled
Password
Function:
0-50 LCP Copy
Option:
No copy
Transfer to LCP all parameters
Transfer from LCP all parameters
Transfer from LCP size indep.
parameters
Function:
0-51 Set-up Copy
Option:
No copy
Copy to set-up 1
Copy to set-up 2
Copy to set-up 3
Copy to set-up 4
Copy to all
Function:
[0]
[1]
[2]
[0]
[1]
[2]
[3]
[0]
[1]
[2]
[3]
[4]
[9]