Troubleshooting; Warnings/Alarm Messages - Danfoss VLT AutomationDrive FC 300 Design Manual

FC 300 Design Guide

Troubleshooting

Warnings/Alarm Messages

"
A warning or an alarm icon appears in the display as well as a text string describing the problem. A warning is
shown on the display until the fault has been corrected, while an alarm will continue to flash on the LED
until the [RESET] key is activated. The table shows the various warnings and alarms, and whether the fault
locks the FC 300. After an Alarm/Trip locked, cut off the mains supply and correct the fault. Reconnect
mains supply. The FC 300 is now reset. An Alarm/Trip can be reset manually in three ways:
Via the operating key [RESET].
1.
Via a digital input.
2.
3. Via serial communication.
It is possible to choose an automatic reset in parameter 14-20 Reset mode. When a cross appears
in both warning and alarm, it means that either a warning comes before an alarm or that you can
define whether a warning or an alarm appears for a given fault. For example, this is possible in
parameter 1-90 Motor thermal protection. After an alarm/trip, the motor will coast, and alarm and
warning will flash on the FC 300. If the fault disappears, only the alarm will flash.
MG.33.B3.22 - VLT is a registered Danfoss trademark
263