Danfoss VLT AutomationDrive FC 300 Design Manual page 120

FC 300 Design Guide
Display Contrast Adjustment
Press [status] and [ ] for darker display
Press [status] and [ ] for brighter display
LEDs:
Green LED/On: Indicates if control section is working.
•
Yellow LED/Warn.: Indicates a warning.
•
• Flashing Red LED/Alarm: Indicates an alarm.
Most FC 300 parameter set-ups can be changed immediately via the control panel, unless a password
has been created via par. 0-60 Main Menu Password or via par. 0-65 Quick Menu Password.
LCP keys
[Status] indicates the status of the adjustable frequency drive or the motor. You can choose
between 3 different readouts by pressing the [Status] key:
5-line readouts, 4-line readouts or Smart Logic Control.
[Quick Menu] allows quick access to different Quick Menus such as:
My Personal Menu
-
Quick Set-up
-
Changes Made
-
- Loggings
[Main Menu] is used for programming all parameters.
[Alarm Log] displays an Alarm list of the five latest alarms (numbered A1-A5). To obtain additional details
about an alarm, use the arrow keys to maneuver to the alarm number and press [OK]. Information about the
condition of the adjustable frequency drive right before entering the alarm mode will be provided.
[Back] reverts to the previous step or layer in the navigation structure.
[Cancel] records the last change or command as long as the display has not been changed.
[Info] supplies information about a command, parameter, or function in any display window.
Exit info mode by pressing either [Info], [Back], or [Cancel].
[OK] is used for choosing a parameter marked by the cursor and for enabling the change of a parameter.
[Hand on] enables control of the adjustable frequency drive via the LCP. [Hand on] also starts the
motor, and it is now possible to enter the motor speed data by means of the arrow keys. The key can
be selected as Enable [1] or Disable [0] via par. 0-40 [Hand on] key on LCP.
External stop signals activated by means of control signals or a serial bus will override
a "start" command given via the LCP.
[Off] is used for stopping the connected motor. The key can be selected as Enable
[1] or Disable [0] via par. 0-41 [Off] key on LCP.
[Auto On] is used if the adjustable frequency drive is to be controlled via the control terminals
and/or serial communication. When a start signal is applied on the control terminals and/or
the bus, the adjustable frequency drive will start. The key can be selected as Enable [1]
or Disable [0] via par. 0-42 [Auto on] Key on LCP.
120
How to Program
MG.33.B3.22 - VLT is a registered Danfoss trademark