Parameter Selection; Changing Data; Changing A Text Value - Danfoss VLT AutomationDrive FC 300 Design Manual

FC 300 Design Guide

Parameter Selection

"
In the Main menu mode, the parameters are
divided into groups. Select a parameter group
by means of the navigation keys.
The following parameter groups are accessible:
After selecting a parameter group, choose a
parameter by means of the navigation keys.
The middle section on the display shows the
parameter number and name as well as the
selected parameter value.

Changing Data

"
The procedure for changing data in a parameter is the same both in the Quick menu or the
Main menu mode. Press [OK] to change the selected parameter.
The procedure for changing data depends on whether the selected parameter represents
a numerical data value or a text value.

Changing a Text Value

"
If the selected parameter is a text value, change the
text value by means of the up/down navigation keys.
The up key increases the value, and the down
key decreases the value. Place the cursor on the
value you want to save and press [OK].
128
How to Program
MG.33.B3.22 - VLT is a registered Danfoss trademark
Group no. Parameter group:
0 Operation/Display
1 Load/Motor
2 Brakes
3 References/Ramps
4 Limits/Warnings
5 Digital In/Out
6 Analog In/Out
7 Controllers
8 Comm. and options
9 Profibus
10 CAN fieldbus
11 Reserved com. 1
12 Reserved com. 2
13 Prog. Features
14 Special functions
15 Drive information
16 Data readouts