Control Key Functions - Danfoss VLT AutomationDrive FC 300 Design Manual

FC 300 Design Guide
How to Program

Control Key Functions

"
Use [STATUS] for selecting the mode of display or for
changing back to Display mode from either the Quick
Menu mode, the Main Menu mode, or Alarm mode. Also
use the [Status] key to toggle single or double readout
mode.
To adjust the display contrast, hold down the [STATUS]
key and use the up or down navigation arrows.
Use [QUICK MENU] for programming the parameters
belonging to the Quick Menu. It is possible to switch
directly between Quick Menu mode and Main Menu mode.
Use [MAIN MENU] for programming all parameters. It
is possible to switch directly between Main Menu mode
and Quick Menu mode.
[ALARM LOG] supplies detailed information about the
last five alarms.
Use [BACK] for stepping backwards.
Use [CANCEL] if it is not desired to carry out a change
in the selected parameter.
Use [INFO] to obtain additional information on the
different display states. [INFO] provides detailed
information whenever help is needed.
Use these four navigation arrows to navigate between
the different choices available in [QUICK MENU],
[MAIN MENU], and [ALARM LOG]. Use the keys to
move the cursor.
[OK] confirms a change of a parameter or chooses the
cursor selected function.
123
MG.33.B3.22 - VLT is a registered Danfoss trademark