Danfoss VLT AutomationDrive FC 300 Design Manual page 194

FC 300 Design Guide
Function:
Enables selection of control source in Instance
21/71 and 20-70.
- Off: Enables control via analog/digital inputs.
- On: Enables control via the bus.
10-2* COS Filters
"
10-20 COS Filter 1
Range:
0 - 65535
Function:
Sets up the filter mask for the status word.
When operating in COS (Change-Of-State),
you can filter out bits in the status word that
should not be sent if they change.
10-21 COS Filter 2
Range:
0 - 65535
Function:
Sets up the filter mask for the Main Actual Value.
When operating in COS (Change-Of-State), you
can filter out bits in the Main actual value that
should not be sent if they change.
10-22 COS Filter 3
Range:
0 - 65535
Function:
Sets up the filter mask for PCD 3. When operating
in COS (Change-Of-State), you can filter out bits in
PCD 3 that should not be sent if they change.
10-23 COS Filter 4
Range:
0 - 65535
Function:
Sets up the filter mask for PCD 4. When operating
in COS (Change-Of-State), you can filter out bits in
PCD 4 that should not be sent if they change.
10-3* Parameter Access
"
10-30 Array Index
Range:
0 - 65536
default setting ( ) display text
*
194
How to Program
This parameter is used for accessing
indexed parameters.
*
*
65535
Par. 10-31 is used to activate storing of data
in non-volatile memory.
* Par. 10-32 is used for EDS file creation.
65535
*
This parameter selects if data parameters received
on DeviceNet should be stored in EEPROM as default.
*
65535
*
65535
This parameter is used to configure the drive
via Devicenet and build the EDS file.
*
0
[ ] value for use in communication via serial communication port
MG.33.B3.22 - VLT is a registered Danfoss trademark
Function:
10-31 Store Data Values
Option:
Off
Store edit setup
Store all setups
Function:
10-32 Devicenet Revision
Range:
0 - 65535 N/A
Function:
10-33 Store Always
Option:
Off
On
Function:
10-39 Devicenet F Parameters
Array [1000]
Option:
No LCP access
0 - 0
Function:
[0]
[1]
[2]
*
0N/A
[0]
[1]
*
0