Danfoss VLT AutomationDrive FC 300 Design Manual page 223

FC 300 Design Guide
2-** Brakes
"
Par. Parameter description
No. #
2-0* DC-brake
2-00 DC hold current
2-01 DC brake current
2-02 DC braking time
2-03 DC brake cut-in speed
2-1* Brake energy funct.
2-10 Brake and over-voltage functions
2-11 Brake resistor (ohm)
2-12 Brake power limit (kW)
2-13 Brake power monitoring
2-15 Brake check
2-2* Mechanical brake
2-20 Release brake current
2-21 Activate brake speed [RPM]
2-23 Activate brake delay
* default setting ( )
How to Program
display text [ ] value for use in communication via serial communication port
MG.33.B3.22 - VLT is a registered Danfoss trademark
Default value 4-set-up
50 % All set-ups
50 % All set-ups
10.0 s All set-ups
0 RPM All set-ups
[0] Off All set-ups
Drive dependent All set-ups
Drive dependent All set-ups
[0] Off All set-ups
[0] Off All set-ups
0.00 A All set-ups
0 RPM All set-ups
0.0 s All set-ups
Change Conver- Type
during sion index
operation
TRUE 0 Uint8
TRUE 0 Uint16
TRUE -1 Uint16
TRUE 67 Uint16
TRUE - Uint8
TRUE 0 Uint16
TRUE 0 Uint32
TRUE - Uint8
TRUE - Uint8
TRUE -2 Uint16
TRUE 67 Uint16
TRUE -1 Uint8
223