Operator-Initiated Rack Change - Beckman Coulter Power Express Instructions For Use Manual

2
The system unlocks the drawer for the rack that you need to remove. Read the control
panel to determine which rack positions to unload.
The control panel displays the Rack Exchange Required
to the rack position in the drawer that requires the rack change.
3
Open the drawer and remove the indicated rack, and any other racks as necessary.
After you remove the rack wait for the position to display the Rack Exchange In Progress
icon:
4
Load empty racks into the vacant positions. After a rack is placed in an empty position,
the position displays the Rack Exchange Completed icon
Note
Note
5
Close the open drawers.
6
Select Restart
the control panel is green after the rack change function is performed correctly.

Operator-Initiated Rack Change

Use the operator-initiated rack change procedure to unload racks at the Outlet module
before they are filled.
1
Select Rack Change
The control panel displays the Outlet Rack Change screen.
2
Select Left Drawer
The system stops unloading sample tubes, activates an audible alarm and flashing
beacon.
3
Select Mute
4
Open the drawer and remove the racks as necessary. After you remove a rack, the
empty position displays the Rack Exchange In Progress icon
B31451AE
.
If the position still displays Rack Exchange Not Required
performed too quickly and was not recognized. Repeat steps to remove and replace
the rack in the Outlet.
If you make a mistake during the rack exchange process (for example, changed the
wrong rack), return the original rack to its original position. Select the Rack
Exchange Completed icon
Exchange Not Required icon
on the control panel to resume operation. The Rack Change screen on
on the Outlet module control panel.
, Right Drawer
on the control panel to silence the alarm and unlock the drawer.
Inlet and Outlet Module Procedures
at the location corresponding
.
on the control panel so that it changes to the Rack
.
, or both to unlock the drawer you want to open.
Unload the Outlet Module
, the rack exchange was
on the control panel.
2
2-15