Beckman Coulter Power Express Instructions For Use Manual page 82

Troubleshooting
Error Code Tables
Table 4.2 Inlet Error Codes (Continued)
Sensor
PM002 ERR
PM002 LIM
PRS00 ERR
PS011 ON
PS012 ON
PS013 ON
PS014 ON
PS015 ON
PS021 ON
PS022 ON
PS023 ON
PS024 ON
PS025 ON
QJ71GF ERR
4-6
Problem
Motor error.
The current register setting
forced the arm to move
beyond the allowable limit
position.
The air pressure is below
the acceptable threshold
level.
Tube presence error at
Carrier Lane #1 on the
loading lane (front loading
lane). The loading arm
attempted to place a
sample tube into the first
carrier on the loading lane,
but another sample tube is
in the carrier.
Tube presence error at
Carrier Lane #2 on the
loading lane (rear loading
lane). The loading arm
attempted to place a
sample tube into the
second carrier on the
loading lane, but another
sample tube is in the
carrier.
The PLC module (QJ71GF)
used for the
communication between
the PLC and LC
malfunctioned.
1.
Place the module in
2. Confirm that nothing interferes with the movement of the
loading arm.
3.
Place the module in
Note
If the error still occurs, reboot the module, then
place it in Auto mode to resume operation.
1.
Place the module in
2.
Place the module in
3. If the error still occurs, contact your Beckman Coulter
representative.
Confirm that the air compressor is on and the auto switch is
working correctly.
1. Manually remove the sample tube from the carrier.
2. Confirm that the tube detection sensor at the carrier works
correctly.
1. Manually remove the sample tube from the carrier.
2. Confirm that the tube detection sensor at the carrier works
correctly.
1. Reset the PLC
2. If the reset does not recover from the error, QJ71GF
module for the PLC can be defective.
Solution
Manual
mode.
Auto
mode to resume operation.
Manual
mode.
Auto
mode to resume operation.
B31451AE