Beckman Coulter Power Express Instructions For Use Manual page 3

These instructions apply to Power Express systems with the software version listed in this
document, as well as previous software versions. When a subsequent software version
changes the information in this document, a new issue will be released.
B31451AE, 5/2018
• Software version 3.5
Changes:
• Updated the Safety Notice section
• Added a symbols glossary to address changes to global labeling requirements and
identify the symbols that relate to product identification, classification, cautions, and
warnings.
Chapter 1, Inlet and Outlet Module Description
• Added the Inlet – Internal View figure
• Updated the Inlet Rack Type section
• Updated the Dynamic Inlet Error Lane section
• Added the Error Lane - Internal (Top) View with Tube Detection System figure
• Added the Bulk Inlet Module section
• Updated the Outlet Module section
• Updated the Outlet Racks section
Chapter 2, Inlet and Outlet Module Procedures
• Updated the Introduction section
• Updated the Load Sample Tubes into the Inlet Racks section
• Updated the Rack Type Abbreviations table
• Updated the Selecting Remap Destination at the Inlet Control Panel (V3.0 and Later)
section
• Added the Selecting Inlet Module Priority section
• Updated the System-Initiated Rack Change section
• Added the Mirror Cleaning section
Chapter 3, Error Recovery Procedures
• Updated the Power Express Module Function Code Definitions table
• Updated the General Error Recovery section
• Updated the Bypass a Module Procedure section
• Updated the Stop Button Recovery section
• Added the Bulk Inlet Module Error Recovery Procedure
• Added the Tube Held Recovery Procedure
• Updated Inlet Module Error Recovery Procedure
B31451AE
Revision History
iii