Beckman Coulter Power Express Instructions For Use Manual page 4

Revision History
• Updated the Error Lane Module Error Recovery Procedure
• Updated the Outlet Module Error Recovery Procedure
• Updated the T-Lane Module Error Recovery Procedure
Chapter 4, Troubleshooting
• Updated the Error Lane Error Codes
• Added the Bulk Inlet Error Codes
• Updated the Outlet Error Codes
• Updated the T Lane Error Codes
• Updated the Inlet (without Bulk Inlet option) diagram
• Added the Inlet with Bulk Inlet Option diagram
• Added the Inlet Tube Seating Mechanism diagram
• Added the Error Lane - Tube Detection System diagram
• Added the Bulk Inlet Conveyor Diagram (1 of 2) diagram
• Added the Bulk Inlet Conveyor Diagram (2 of 2) diagram
• Added the T-Lane (6 Diverter) diagram
• Added the Optional Track Sensor Diagram
B31451AD, 07/2016
Cennexus software version 3.0
Line Control software version 3.0
Updated EC Rep address
Updated Safety Notice
Updated Connections:
• Dynamic Inlet Module
• Outlet Module
Added new procedure:
• Selecting Remap Destination at the Inlet Control Panel (V3.0 only)
• Error Lane Module Error Recovery Procedure
• T-Lane Module Error Recovery Procedure
Updated existing procedures:
• Load Sample Tubes into the Inlet Racks
• Load Racks into the Inlet Module
— System-Initiated Rack Change
— Operator-Initiated Rack Change
• Remove Sample Tubes from the Error Lane
• Unload the Outlet Module
— System-Initiated Rack Change
— Operator-Initiated Rack Change
• Error Recovery General Information
iv
B31451AE