Check The Event Log (Page 11-11) To Verify That The Trunked Ports Are Operating Properly; Cli: Viewing And Configuring A Static Or Dynamic Port Trunk Group; Using The Cli To View Port Trunks; Cli: Viewing And Configuring A Static Or Dynamic - HP ProCurve series 2500 Management And Configuration Manual

Optimizing Port Usage Through Traffic Control and Port Trunking
Port Trunking
8.
Check the Event Log (page 11-11) to verify that the trunked ports are
operating properly.
CLI: Viewing and Configuring a Static or Dynamic Port
Trunk Group
Trunk Status and Configuration Commands

Using the CLI To View Port Trunks

You can list the trunk type and group for all ports on the switch or for selected
ports. You can also list LACP-only status information for LACP-configured
ports.
Listing Static Trunk Type and Group for All Ports or Selected Ports.
Syntax:
Omitting the <port-list> parameter results in a static trunk data listing for all
LAN ports in the switch.
This example uses a port list to specify only the switch ports an administrator
wants to view:
Figure 6-6. Example of a Show Trunk Listing for Specific Ports
6-18
Connect the trunked ports on the switch to the corresponding ports on
the opposite device. If you previously disabled any of the trunked ports
on the switch, enable them now. (See "Viewing Port Status and Configur-
ing Port Parameters" on page 6-2.)
show trunks
show lacp
trunk
interface lacp
show trunks [<port-list>]
below
page 6-19
page 6-21
page 6-22