Display Static Port (And Trunk) Acl Assignments - HP E3800-24G-PoE+-2SFP+ Access Security Manual

HP Switch(config)# show access-list vlan 20
Access Lists for VLAN 20
Inbound Access List: Account-2
Type: Extended
Outbound Access List: 101
Type: Extended
Ipv6 VACL Access List: Blue-Group
VACL Access List: None
Connection Rate Filter Access List: None
Figure 10-34. Example of Listing the ACL Assignments for a VLAN
Note
For example, the following output shows that all inbound IPv6 traffic and the
inbound and outbound, routed IPv4 traffic are all filtered on VLAN 20.

Display Static Port (and Trunk) ACL Assignments

This command lists the identification and type(s) of current static port ACL
assignments to individual switch ports and trunks, as configured in the
running-config file. (The switch allows one static port ACL assignment per
port.)
Syntax: show access-list ports < all | port-list >
Lists the current static port ACL assignments for ports and
trunks in the running config file.
This information also appears in the show running output. If you execute write
memory after configuring an ACL, it also appears in the show config output.
For example, the following output shows IPv4 and IPv6 ACLs configured on
various ports and trunks on the switch:
IPv4 Access Control Lists (ACLs)
Displaying ACL Configuration Data
• An extended IPv4 ACL named "Account-2" is
assigned to filter routed IPv4 traffic entering the
switch on VLAN 20.
• An extended IPv4 ACL named "101" is assigned
to filter routed IPv4 traffic leaving the switch on
VLAN 20.
• An IPv6 ACL named "Blue-Group" is assigned to
filter IPv6 traffic entering the switch on VLAN 20.
• There is no ACL configured to filter all IPv4 traffic
entering the switch on VLAN 20.
• There is no IPv4 Connection Rate Filter ACL
assigned to VLAN 10. Refer to the chapter titled
"Virus Throttling (Connection-Rate Filtering)" in
the latest Access Security Guide for your switch.
10-101