Table of Contents
Advertisement
Chapter 4. Port Management
Enter up to 63 characters to be descriptive name for identifies this port.
Link:
The current link state is displayed graphically. Green indicates the link is up
and red that it is down.
Current Link Speed Status:
Provides the current link speed of the port.
Configured Link Speed:
Selects any available link speed for the given switch port. Only speeds
supported by the specific port is shown. Possible speeds are:
Disabled - Disables the switch port operation.
Auto - Port auto negotiating speed with the link partner and selects the highest
speed that is compatible with the link partner.
10Mbps HDX - Forces the cu port in 10Mbps half duplex mode.
10Mbps FDX - Forces the cu port in 10Mbps full duplex mode.
100Mbps HDX - Forces the cu port in 100Mbps half duplex mode.
100Mbps FDX - Forces the cu port in 100Mbps full duplex mode.
1Gbps FDX - Forces the port in 1Gbps full duplexFlow Control :
When Auto Speed is selected on a port, this section indicates the flow control
capability that is advertised to the link partner. When a fixed-speed setting is
selected, that is what is used. The Current Rx column indicates whether pause
frames on the port are obeyed, and the Current Tx column indicates whether
pause frames on the port are transmitted. The Rx and Tx settings are
determined by the result of the last Auto-Negotiation.
Check the configured column to use flow control. This setting is related to the
setting for Configured Link Speed.
Maximum Frame Size
Enter the maximum frame size allowed for the switch port, including FCS. The
range is 1518-10240 bytes.
Buttons
Refresh:
You can click them for refresh the Port link Status by manual
Apply:
Click to save changes.
Reset:
69
Advertisement
Table of Contents
