Table of Contents
Advertisement
Chapter 10. Multicast
Specify whether the traversed IGMP/MLD control frames will be sent as
Untagged or Tagged with MVR VID. The default is tagged.
Priority:
Specify how the traversed IGMP/MLD control frames will be sent in
prioritized manner. The default Priority is 0.
LLQI:
Define the maximum time to wait for IGMP/MLD report memberships on a
receiver port before removing the port from multicast group membership. The
value is in units of tenths of a seconds. The range is from 0 to 31744. The
default LLQI is 5 tenths or one-half second.
Interface Channel Profile:
When the MVR VLAN is created, select the profile to expand the
corresponding multicast channel settings for the specific MVR VLAN. The file
established on Filtering Profile Table.
Port:
The logical port for the settings.
Port Role:
Configure an MVR port of the designated MVR VLAN as one of the following
roles.
Inactive: The designated port does not participate MVR operations.
Source: Configure uplink ports that receive and send multicast data as source
ports. Subscribers cannot be directly connected to source ports.
Receiver: Configure a port as a receiver port if it is a subscriber port and should
only receive multicast data. It does not receive data unless it becomes a
member of the multicast group by issuing IGMP/MLD messages.
Be Caution: MVR source ports are not recommended to be overlapped with
management VLAN ports. Select the port role by clicking the Role symbol to
switch the setting. I indicates Inactive; S indicates Source; R indicates
Receiver. The default Role is Inactive.
Immediate Leave:
Enable the fast leave on the port.
Buttons
Add New MVR VLAN:
237
Advertisement
Table of Contents
